WALLTITE® Injection Insulation

Used to reduce the heat loss of existing and new build cavity walls. Installed as a liquid through a pattern of 12mm pre-drilled holes it expands within the cavity to gently fill each void eventually setting as a rigid polyurethane high-density insulation.

 

Features and benefits

  • Low thermal conductivity 
  • Adds structural strength prolonging the life of the building
  • Seamless airtight insulation system with no joints or gaps 
  • Applied throughout the UK and Ireland by BASF Foam Masters 
  • Fast & easy applied with no waste, minimum fuss and maximum effect 
  • No VOC’s, CFC’s, formaldehyde and has no harmful side effects
  • Will not settle of sag and will last lifetime of building
  • BASF polyurethane is certified to BS EN ISO 9001, ISO/TS 16949:2002 & BS EN ISO 14001.
  • CE Marked

Technical downloads

WALLTITE® cavity wall insulation.

Walltite full fill cavity wall insulation

Walltite Cavity Wall InsulationWALLTITE cavity wall foam insulation is used to reduce the heat loss of existing and new build cavity walls consisting of masonry innerand outer leaf construction. Installed as a liquid through a pattern of 12mm pre-drilled holes it expands within the cavity to gently fill each void eventually setting as a rigid polyurethane high-density insulation. WALLTITE seals the cavity thereby preventing air leakage. The increased airtightness effect adds to the systems already superior thermal performance helping to reduce energy bills and creating a more comfortable living environment.  

 

Technical data

SpecificationFull fill, closed cell, cavity wall insulation and stabilisation system
NBS clauseF30, 10 and 150 P11, 50, 220, 230 and 24
Lambda 90/900.026 W/mK
Closed cell content94.4%
Adhesion to brick231k
 

Typical U-values

Thickness of WALLTITE (mm)U-value (W/m2K)
1500.18
1300.21
1000.24
Walltite partial fill cavity wall insulation
Walltite Insulation Refurb

WALLTITE cavity wall foam insulation is ideal for restoring the structural stability and reducing the heat loss associated with existing cavity walls already partially filled with rigid board insulation.

Walltite is also ideal where the need to reduce air leakage is important. The insulation seals the cavity, does not settle or allow air to pass through. Installed as a liquid through a pattern of 12mm pre-drilled holes it expands within the cavity to gently fill each void eventually setting as a rigid polyurethane high-density insulation.

Walltite Cavity Wall Insulation Partial

 

Performance data

Typical u-value prior to Walltite installation (assumes 60mm existing EPS insulation board with 40mm cavity) 0.51 W/m2k
Typical u-value post Walltite installation (assumes 60mm existing EPS board with 40mm Walltite) 0.29 W/m2k
Thermal performance improvement in percentage terms 75%
Airtight Yes
Water resistant Yes

 

WALLTITE® preparation video

WALLTITE® application video

Share this post

error: Content is protected !!